Congratulations! You are now on the waiting list, please check your inbox for our confirmation email!
Register Account
Lerway Seedling Heat Mat - 58 x 29 cms
Lerway heat mats (also called a seedling mat or heat pad), keep seedlings, cuttings and cold-sensitive plants toasty warm and growing even when the temperature drops. Great to have on hand for a little plant-life-saving too, for drying over-watered plants out faster to help prevent root rot, and to help roots recover after repotting or root damage.
These mats are water-resistant, thick and sturdy, providing a good solid base under your pots, seedling trays or grow house, yet still flexible enough to roll up and store away when needed. At just 21 watts they are very low on power consumption (running a heat mat for 8 hours a day, 7 days a week averages 5 cents a day or $4.51 to run for 3 months right through winter*).
Temperature
Most seedlings germinate best with a soil temperature around 25 to 35 degrees, and for most plants, roots grow best with a soil temperature of 18 to 25 degrees. Grab your Lerway heat mat (and a grow light unless you're blessed with great natural light all year), and you're good to grow right through winter. Lucky plants!
These heat mats lift the soil temperature 10 to 20 degrees above the ambient temperature. In more enclosed spaces, or with covered pots or a grow house on top, it'll maintain a warmer temperature, so if you want it to run a bit cooler, increase space and airflow.
Designed to work by themselves without a controller, however they are compatible with a heat pad controller (not included, available separately), if you prefer more exact control or want to set different daytime and night-time temperatures (which does also happen naturally if you just leave it on since the night-time ambient temperature is lower anyway). And if you don't have one already, definitely get yourself a temperature meter at the same time to keep an eye on the highs and lows (you can also change the environment to adjust the heat without a controller - tips below).
Size
The Lerway heat mat measures 52cms long x 25cms wide (the standard size for a seedling heat mat), and has a nice long 1.8 metre cord with NZ plug. It comes rolled up in a branded box as shown in the photos.
My review (and tips for use)
I have tried the solid Egmont, flexible Cultiv8 and Inkbird Plus, and comparing those to the Lerway, I find it a bit thicker (in a good way), and a little slower to heat up than the speedy Inkbird Plus. Give your Lerway mat a good 15 to 30 minutes to gently warm up and it'll maintain your seedlings and cuttings roots at a nice toasty 10 to 20 degrees above room temperature. I also find they don't heat quite as evenly as the Inkbird Plus.
These pads are also a little thicker than the Inkbird and Cultiv8, so arriving rolled up in their box means you'll likely need to turn on and heat them up to flatten them out before first use (they are pretty determined to stay rolled up at first). I just popped mine on for about half an hour with a couple of heavy books on top and it was good to go.
This tip isn't only for the Lerway brand, but with both a heat mat and a grow light going, soil will dry out faster or water props evaporate faster, so you'll need to keep an eye on watering so the roots aren't left high and dry. I really like that Lerway are also water-resistant so no problem with the occasional spill, just wipe it off when you notice it.
Ways to control the temperature (without buying a controller)
If a heat mat controller isn't in budget, here are some budget-friendly DIY ways to increase or decrease a heat mat's temperature by changing the environment instead:
You can put your prop tank, grow house, seedling trays or potted plants directly on a heat pad for higher warmth, however some airflow is recommended (even if it's just leaving one end slightly uncovered), rather than completely covering the pad.
The surface the heat pad is on changes the temperature also. Placing on top of colder surfaces or materials like concrete will reduce the temperature, and placing on an insulated surface will help maintain a higher temperature.
A black neoprene foam pad (available by the metre from stores like Spotlight), can be cut to size and used below the pad to increase insulation, helping the pad reach and maintain higher temperatures.
You can cool down the temperature of a heat mat by increasing airflow. One simple way is to use a few round neoprene foam pads (also called grippers). Put them on top of the heat mat, then put your pots etc on those pads, rather than directly on the mat . That creates a gap for excess heat to escape. You can buy grippers or foam pads from hardware stores (often sold as pads to stop furniture marking floors).
Covering the plants (putting them inside a dome, prop tank or grow house), helps retain the heat and also increases humidity and reduces water loss.
My last tip is to get yourself a mini 2-in-1 hygrometer and thermometer to keep an eye on the minimum and maximum temperature and humidity to help you create the ideal environment for your plants :)
*cost per day based on 8 hours use per day, 7 days a week, at $0.32 cents per kilowatt-hour (kWh), based on the 2023 average NZ electricity rates published by Canstar Blue
Shipping and Delivery FAQ's
SHIPPING RATES
FREE shipping for orders $99+. For orders under $99: Auckland Standard $5 or rural $9. Rest of the North Island and South Island: Standard $8 or rural $12. Plants and overweight/oversize parcels have separate rates. See holiday dates >
IN STOCK IN NZ
Stock levels are live. Everything showing in stock online, is in stock right here, right now, ready to ship. No drop shipping from other countries. No delays.
SHIPPING DAILY
Orders ship every week-day. Orders placed before 7pm Mon to Thurs leave the next morning. Zoom zoom! Fri morning orders usually ship Friday. Fri, Sat & Sun orders up to 4pm Sun leave Mon (or the next working day after public holidays).
More about shipping and delivery >
Why choose to buy from Love That Leaf?
100% NZ
When you buy from me you're supporting a small, local, family business. Love That Leaf is a registered NZ business and is 100% NZ owned and operated. Orders ship daily, Monday to Friday, from Auckland. Usual delivery is 1 to 3 working days NZ wide.
I'LL PUT IT RIGHT
I stand by everything I sell. I'll always help if something goes wrong. When you choose to buy from a registered NZ business (like me), you're also covered by the Consumer Guarantees Act, unlike overseas purchases or private sales, where you can end up stuck with no rights if anything arrives damaged or stops working.
SUPER SUPPORT
I'm here for support and advice anytime, even if you haven't bought from me yet. A lot of lovely people helped me along my plant journey, and I want to pay it forward. Please don't hesitate to ask for help. No obligation at all to purchase.